Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— VIctor Osorhan
—— Matthias Frisch
—— Giorgio Pattarini
—— Ana Silva
—— Milucci Christian
—— Ann Byrne
Although it is not too difficult to use an astronomical telescope, there are a few things you need to pay attention to.
1. Before observing, first use the finder to find the target.
2. Use low magnification eyepieces first, then use medium and high magnification eyepieces, and adjust the focus when changing the eyepieces.
3. Don't be bothered by the upside-down and left-right images that you see. This is normal for astronomical telescopes.
4. After the finderscope is fixed, do not touch it again.
5. Never observe the sun directly, whether through the finder or the main tube
Let's talk about the use of astronomical telescopes. It is not too difficult. The main reason is that the finderscope needs to be adjusted when it is used for the first time. The steps are mainly divided into 3 steps:
1. Installation
After purchasing, remember to check the install video or manual, and then install it according to the video or instructions.
2. Debug the finder
① In the daytime, aim the main lens barrel at a distant target, such as a tall building in the distance, a mountain in the distance, etc., first install a low-magnification eyepiece, such as 20mm.
After roughly aligning the lens barrel to the target, adjust the focus until the target is clearly visible and the target is at the center of the main lens.
②. Adjust the three screws on the finderscope, and then adjust the target seen by the main mirror to the center of the cross of the finderscope.
③. Replace the high-magnification eyepieces, such as 10mm, 5mm, and repeat steps ① and ② again. When debugging, the target in the main lens barrel should always be controlled at the center of the cross of the finder.
3. Observation
First use your eyes to roughly align the observation target, and then adjust the finder mirror until the target is in the center of the finder mirror cross.
If the finder is adjusted accurately, there should be an image in the eyepiece at this time.
Factory Address:151# Bohai Road, Xindu District, Chengdu, Sichuan, China (Mainland) | |
Sales office:151# Bohai Road, Xindu District, Chengdu, Sichuan, China (Mainland) | |
+86-28-89346527 | |
allie_tontube@outlook.com | |